Losing heat during a Missouri cold snap is more than uncomfortable — it can be dangerous for children, older adults, pets, and can put your pipes at risk of freezing. Hooten Heating & Cooling responds to no-heat emergencies 24/7 across Goodman and McDonald County, with safe phone guidance and fast arrival.
We work on every common rural heating setup — propane and gas furnaces, electric heat, and heat pumps — and carry the parts that solve most no-heat failures on the first visit.
Common Causes of No Heat
Failed ignitor or flame sensor
A worn ignitor or dirty flame sensor is one of the most common no-heat causes and often a same-visit fix.
Safety lockout
A furnace can lock out on a safety fault; it needs diagnosis, not repeated resets that can mask a real hazard.
Thermostat or control failure
A dead thermostat or faulty control board can cut the heat entirely.
Out of propane or gas-supply issue
We help confirm fuel supply and diagnose gas-valve or regulator problems.
Heat pump defrost fault
A heat pump stuck in defrost or iced over can leave you with cold air until it's repaired.
Blower motor failure
If the blower won't run, heat can't move through the house even when the furnace fires.
No Heat in a Cold Snap? First 30 Minutes
A few safe checks can restore heat or help us fix it faster — without opening the furnace or bypassing a safety control.
Quick checks that sometimes fix it
- 1Set the thermostat to heat and above room temperature; replace the batteries if the screen is blank.
- 2Check whether the filter is clogged and note the size before replacing it.
- 3Make sure the furnace power switch and breaker are on — but don't keep resetting one that trips again.
- 4Confirm you have fuel: check the propane tank gauge or that gas service is on.
- 5If a gas or propane furnace won't stay lit, don't relight it repeatedly — call us.
Short-cycling or a safety lockout needs diagnosis, not repeated restarts.
Stay warm & protect your home
- 1Keep the home warm with approved backup heat — never an oven or an unvented heater.
- 2Open cabinet doors under sinks and let faucets drip if pipes could freeze.
- 3Move vulnerable family members, older adults, and pets to the warmest room.
- 4If you smell gas or a carbon-monoxide alarm sounds, go outside and call from there.
Tell us if pipes are at risk so we can prioritize your call.
Our Process
Every job follows a clear, honest process — so you always know what's happening and why.
- 1
Call and safe triage
We help you check the thermostat, filter, breaker, and fuel safely, and gather access details.
- 2
Priority dispatch
No-heat calls with safety risk get prioritized; we give you the soonest arrival window.
- 3
Diagnose the fault
We pinpoint the cause — ignition, controls, fuel, blower, or defrost.
- 4
Written pricing & repair
You approve the price and we restore heat, often on the first visit.
- 5
Combustion safety check
We verify safe operation and rule out carbon-monoxide concerns before leaving.
A no-heat call in a Missouri cold snap isn't just uncomfortable — with January lows near 26°F it can put children, older adults, pets, and your pipes at real risk. We prioritize these calls day or night and carry the parts behind most no-heat failures so we can often restore heat on the first visit.
We service every rural heating setup out here — propane and natural-gas furnaces, electric heat, and heat pumps — and we verify safe combustion and rule out carbon monoxide before we leave.
What Affects the Price
No-heat repairs range with the fault and after-hours timing (emergency ranges commonly $150–$3,500). We give you written pricing before any repair and are upfront about after-hours rates on the call.
No-Heat Emergency
$150–$3,500
By fault & timing
Standard Repair
$75–$3,500
Business-hours range
Hourly Labor
$55–$225
Avg. total $210–$650
After-Hours Rate
Quoted on call
Told before we dispatch
Researched, aggregated ranges to help you plan — not a quote. Your written price depends on the specifics below.
- Fuel type and specific fault
- Time of the call (nights, weekends, holidays)
- Parts required (ignitor, board, motor, gas valve)
- Equipment access and condition
What's Usually Behind a No-Heat Call
Most no-heat failures come down to a few common causes — and we stock the parts for them.
Ignition
A worn igniter or dirty flame sensor is the most common cause — often a same-visit fix.
Controls & safety
A dead thermostat, a failed control board, or a safety lockout can cut the heat entirely.
Fuel & airflow
Out of propane, a gas-valve fault, a failed blower, or a heat-pump defrost problem.
Need No-Heat Repair Now?
Call Hooten Heating & Cooling for fast, honest no-heat emergency repair across Goodman, McDonald County & Southwest Missouri.
Where We Provide No-Heat Repair
Serving Goodman and communities across McDonald County and Southwest Missouri: